Discussion Boards > How To and Technical Information
Marx William Crooks repair
cndctr111:
Have never rebuilt a William Crooks but many other Marx motors. Just wondering about the drivers, if they come off and go back on as easily as the Baldwin drivers, Also right now I notice the drive rods go opposite one another, is this common? Should I pair them the same?
Dino
starfire700:
I would have to check one, but the drive rods could be same, halved or quartered, real train drive rods are quartered, meaning each is 90 degrees off from the other. You should be able to drive the wheels off with a punch and re-install with a vise. Make sure they do not wobble and they must be aligned or the side-rods will bind.
cndctr111:
Thanks, these drivers were halved. I have it all pulled apart, doing a thorough tune up, I’m going to place the drivers the same and see how that works out. Thanks for the input.
cndctr111:
After full motor tune up and replacement of smoking unit. I had to fix the light box as it was broken as well. I ended up placing the drive rods going the same direction, it runs great. Very happy with my first William Crooks set. I'm wondering, is there something missing from the front boiler under the lamp?
pjdog350:
I’d like to see that running.
Navigation
[0] Message Index
[#] Next page
Go to full version